A powerful dynamo front light best suited to bottle dynamos.

• Lumotec Plus round front light with integral reflector and bi directional Z-diode which prevents over voltage.
• Supplied with 6V, 2.4W bulb.
• Upto 17lux output.
• LED Standlight which stays on for upto 4 minutes when not moving
  
• Can be single or twin wired.
• No switch, so recommended for use with a bottle dynamo only.
• Can be upgraded to 6V, 3.0W bulb
• Easy bulb replacement, no tools required
• Anticorrosive and unbreakable

• Easily replaceable roller
• Light touch button engages the roller (no more sore fingers)
• Pressure adjustment - so you can vary the roller pressure on your tyre - hand for when it is wet
• Secure attachment system rules out unintentional disconnection
• Creates power when the wheel runs forward or backwards
• Twin wire suplied - no frame earthing required
• Two plug connections
• Works with virtually any brand of dynamo light!
• Choose left or right hand mount depending on which side of the road you ride!

• Fit your B&M rear light to the seatpost clamp bolt of your bike.
• Bracket attaches to the seat bolt.
• Allows a pannier rack style dynamo light to be attached to the bike when a rack is not available.
• Fits 50 or 80mm lights

• A simple and inexpensive way to fit your B&M rear light to the rear pannier rack of your bike.
• Designed to mount onto pannier rack which does not have holes at the end for a light.
• Suitable for 50mm or 80mm fittings.
• Supplied with fitting kit.

• Designed to allow the fitting of a bottle dynamo to a frame that does not have the mounting plate welded onto it.
  
• Fits seat/chain stays from 15mm to 25mm in diameter (rounded).
• The bracket body is cast aluminium and the fittings are stainless steel
  
• Can also be used as a sturdy carrier, rack or mudguard mount
  
• One bracket per pack

• This model has a standlight and is for use with BOTTLE dynamos.
• 60 lux output with the light beginning a few feet in front of the bicycle
• Does not have an integral reflector - hence the light output is brighter.
  
• Includes headlamp bracket for fork crown fitting
• Also includes cables for dynamo
• Also has a standlight (no batterries required)
• Always ready for use!

• The wire measures 6 feet (185cm)
  
• It's a dual wire (+/-) (one side has a white stripe)
• Bare wire one end, plug for the light end.

A handy spare to own....

Dull, but difficult to source when you need them!

These are often called 'spades' and they allow you to connect wires from a light or dynamo to the terminals of another light or dynamo (both hub or bottle).

These spades are perfect for use with the double core wires of Busch and Muller lights. They are also insulated (the red plastic collar you see in the picture) which means there can be no short circuits with these!

• Overall length  - 20mm
• Wire diameter 0.5-1.0mm
• Terminal width 2.8mm
• For best results - solder wire into the spade itself.
• Wires not included (see above)
  
• Sold as a pair of identical spades - ie two!

Looks like a Lego brick but isn't!

If you have a hub dynamo you will probably loose at least one of these every now and again!

Allows you to connect the bare end wires of your dynamo light to the terminal on the hub itself.

• Made of plastic
• Reusable
• Two parts clip together to secure wire firmly

Sold in singles